Operational Test /To Trigger An Additional Lubrication Cycle; Putting Into Operation; Repair - Lincoln 236-13870-2 Instructions De Service

Owner Manual
Operating Instructions

Operational Test /To Trigger an Additional Lubrication Cycle

Fig. 15: LED of the printed circuit board
1 - LED, left-hand
power supply
2 - Rotary switch
"pause time"

Putting Into Operation

Repair

• The defective printed circuit boards should be suitably packed
and returned to the factory.
Page 10
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
10012426a
3 - LED, right-hand,
indication of operation
4 - Pushbutton for
additional lubrication cycle
• To check the function of the pump it is possible to perform
an operational test.
Pumps 203 installed on machines
* If necessary, switch on the power
* Switch on the machine contact
Pumps 203 installed on commercial vehicles
* If necessary, switch on the battery voltage
* Switch on the driving switch
• To check whether power is applied to the printed circuit
board, observe whether the left-hand LED 1, Fig. 15, is lit.
* Press the pushbutton 4 for triggering an additional lubrica-
tion (illuminated pushbutton or pushbutton on the switch
cabinet) until the right-hand LED 3 lights up (> 2 seconds).
• The right-hand LED shows the following functions:
- lubricating time
- monitoring time (in normal cases it is as long as the lubri-
cating time, in the case of a fault: 5 or 30 minutes)
- faults
• When an additional lubrication cycle has been triggered, a
shorter pause time elapses, followed by a normal lubrica-
tion cycle.
• Additional lubrication cycles can be triggered at any time
• When the machine contact (external contact) or the driving
switch is switched on, the printed circuit board and thus the
pump are ready for operation.
• If the printed circuit board must be replaced, a model M 00 will
always be delivered. See chart in Technical Description.
• Before installing another printed circuit board, take care that
the jumper is set to the same position as on the old printed
circuit board.
2.6A-28003-B06