Makita LS1219 Manual De Instrucciones página 6

Always secure all moving portions before
Check the blade carefully for cracks or dam
age before operation. Replace cracked or dam
aged blade immediately. Gum and wood pitch
hardened on blades slows saw and increases
potential for kickback. Keep blade clean by
¿rst removing it from tool, then cleaning it with
Never use gasoline to clean blade.
occur. KICKBACK occurs when the blade
binds in the workpiece during a cutting oper
ation and the saw blade is driven rapidly
ous personal injury can result. If blade begins
to bind during a cutting operation, do not con
Use only Àanges speci¿ed for this tool.
Be careful not to damage the arbor, Àanges (espe
cially the installing surface) or bolt. Damage to
these parts could result in blade breakage.
Make sure that the turn base is properly
Use the holes in the base to fasten the saw to a
stable work platform or bench. NEVER use tool
where operator positioning would be awkward.
Make sure the shaft lock is released before the
Be sure that the blade does not contact the
turn base in the lowest position.
Hold the handle ¿rmly. Be aware that the saw
Make sure the blade is not contacting the
workpiece before the switch is turned on.
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced blade.
thing abnormal.
abrasive wheels may cause an injury.
be toxic. Take caution to prevent dust inhala
Complies with 21CFR
1040.10 and 1040.11
AVOID EXPOSURE-Laser
radiation is emitted from
this aperture
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM
Maximum Output
<1mW,Wavelength:655nm
CLASS II LASER PRODUCT
Symbols