SATA AE1017H Instrucciones De Uso página 63

8.3 Adjustment of gap between tire-changing head and rim
8.3.1
8.3.2 Adjustment of square locking plate for front and rear gaps
Close the air source and adjust the two square locking plate jackscrews at the rear of the upper seat of column with a #6 internal
hexagonal wrench (Fig. 8-3B). If the gap is too large, fit the jackscrew and lock it with a #18 external hexagonal wrench; if the gap is too
small, adjust it in the opposite direction.
8.4 Foot pedal switch repair
Turn off the power supply and air source, and remove the protective cover. Take out the foot pedal chassis before repairing the switch. (Fig.
8-4)
AE1017H
中文
EN DE
Adjust the locking plate of the hexagonal shaft for the
upper and lower gaps; close the air source and remove the
protective cover of the vertical hexagonal shaft. If the gap
is too large, adjust the front nut of the locking plate of the
shaft downwards with a #16 exterior hexagonal wrench (Fig.
8-3A); if the clearance is too small, adjust it upwards.
Fig. 8-3
Fig. 8-4
RU KO PT JA ES
63