Operating Instructions - Kobalt SGY-AIR87TZ Manual Del Usuario

ASSEMBLY INSTRUCTIONS
4. Pour paint into paint cup and put on cover
(See Fig 4. Oil and water extractor and air
compressor not included).
OPERATION INSTRUCTIONS
Proper handling of the gun is essential for obtaining a good finish. The gun should be held at a
90 angle the surface being covered, and moved parallel to it. For precise control of the gun and O
material, the trigger should be released before the end of the stroke. Hold the gun 6 to 12 inches
away from the surface depending on material and atomizing pressure. For a uniform finish, lap
each stroke over the preceding stroke, making sure the spray is smooth and wet. Using the
lowest possible atomizing air pressure will reduce over spray and provide maximum efficiency
(See Fig. 5).
During normal use, the air cap wings are horizontal and the air cap should be pointed up as
shown here (See Fig. 6). This provides a vertical fan-shaped pattern which gives maximum and
even material coverage as the gun is moved back and forth parallel to the surface being finished.
5
6 to 12 inches
Start
Pull
stroke
trigger
RIGHT
Light coat
Even and wet coat
Release End of
trigger stroke
4
Load paint
Heavy coat
WRONG
7
6
The air cap wings
are horizontal.