Repair Instructions - Kobalt SGY-AIR87TZ Manual Del Usuario

REPAIR INSTRUCTIONS

Remove air pressure from air hose / gun.
Take care not to damage the seals on the gun body when
CAUTION:
removing the air distribution ring.
1. Remove the nozzle set:
a. Remove air cap w/ring (See Fig. 1)
b. Unscrew the fluid adjustment knob (See Fig. 2)
c. Pull out needle spring and paint needle (See Fig. 3)
d. Remove paint nozzle using wrench provided (See Fig. 4)
1
4
2. Pull out the air distribution ring using needle-nose pliers,
and remove dirt (See Fig. 5)
NOTE: Make sure that dirt has not settled in the sealing surfaces
and no scratches prevent optimum sealing performance.
Reconnect air hose with spray gun and set to desired PSI.
pin marked with an arrow (1) fits smoothly into the hole marked (2) (See Fig. 6)
Then firmly push in the air distribution ring (See Fig. 7) Insert the paint nozzle and
tighten slightly. Then remove it again. Make sure the air distribution ring
fits securely against the gun body.
2
8
3
5