Assembly Instructions; Operating Instructions - Kobalt SGY-AIR70TZ Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Mount the spray gun filter (C) with hand onto
the air inlet (I) of spray gun by connecting the
female threads of filter (C) with the male
threads if the air inlet (I). Use thread sealant
tape (not provided) turning clockwise for an
air-tight connection (See Figure 1).
DO NOT OVERTIGHTEN
2. Connect air hose with the male threads of the
filter (C) turning clockwise to tighten. Use
thread sealant tape (not provided) turning
clockwise for an air-tight connection
(See Figure 2).
DO NOT OVERTIGHTEN
3. Set the working pressure to 30-50 psi
depending on the amount of fluid flow and
atomization as required for your specific
application. Do not exceed spray gun maximum
pressure.
NOTE The working pressure refers to the air line
pressure when the spray gun trigger (K) is pulled
fully under working conditions.

OPERATING INSTRUCTIONS

NOTE
Before using desired paint in the spray gun, spray a compatible thinner or solvent
through the gun to remove any contaminants and residues.
Thin latex paints properly in accordance with the paint manufacturer's instructions
before spraying. If paint can not be thinned, the paint should not be used in the
sprayer.
Before adding paint make sure all thinner or solvents are removed from the spray
canister.
It is recommended to place a drop cloth or other collection device under canister
so that if any paint spills, you can easily collect the paint and properly discard.
Fill the canister (L) about 3/4 full and start the air compressor.
Set up a piece of cardboard or other scrap material to use as as a target to test
spray. Continue to test spray until the desired spray pattern is achieved.
If during your test spray the paint
Do not exceed paint manufacturer ' s thinning recommendations.
WA R N I N G
WA R N I N G
appears too thick, add a small amount of thinner.
1
2
8