Steelcase Answer Manual De Montaje página 9

®
For Parallel, One-Sided with Mid-Storage Support
(continued)
7.
Align the inside face of the stanchion brackets to the
top cap lines and secure with the 1/2" long bolts provided.
TIP: Pencil lines on the outside of the stanchions can help
assembly by showing the stanchion bracket channel locations.
TIP: 9-3/8" and "X" long spacer blocks can be used to aid in
positioning the stanchion brackets.
8.
Carefully set the mid-storage unit onto the stanchion brackets
(8a) and mark the locations for the support brackets (8b).
Remove the mid-storage unit (8c).
9.
If the mid-storage supports align with the lower
support surface, use the support brackets as a gauge
to mark their mounting hole locations (9a). If the
mid-storage supports do not align with the lower
support surface, position the support brackets
3/32" from the inside of the mid-storage supports
(9b), and mark their mounting hole locations. Drill
1/8" diameter pilot holes through the laminate
surface only (9c), (hole depth only a 1/4"). Secure
each mounting bracket with two (2) 1" long truss
head screws provided (9d).
8b
9b
3/32"
7
8a
8c
MID-STORAGE
SUPPORT
7
7
9a
9c
9d
TAPPED HOLE
BRACKET
CLEARANCE
HOLE BRACKET
SUPPORT
BRACKET
1/4"
Page 9 of 100
100137 Rev A