Chain Installation - CAMPAGNOLO C10 HD-L Manual De Instrucciones

1. CHAIN INSTALLATION

WARNING!
An incorrectly assembled chain can break, resulting in an accident, personal injury, or
death. If you have any doubt whatsoever regarding your ability to properly perform any of
the operations in this manual, please take your bicycle to a qualified repair shop.
• Determine the correct length of the chain by putting it onto the smallest sprocket and chainring
and check that the dimension H (Fig. 2) does not exceed 10÷15 mm.
• Perform all of the following operations and remove extra links from the side of the chain opposite
the external link, which is identified by the plastic band and the adhesive "WARNING!" label.
WARNING!
NEVER remove or modify in any way whatsoever this external link, which is permanently identified
by the stamped production batch number, since it has the calibrated holes need to close the chain.
2
16
• To cut the chain:
- fit the link to be opened in tool UT-CN200
(Fig. 3) taking care to end with an internal
link
- clamp the link with the special clamping
device (A) (Fig. 4)
- tighten the tool until the small pin emerges
completely from the hole in the link (Fig. 5)
4
ENGLISH ENGLISH
3
UT-CN200
5
A
17