Festo CPV GE-ASI-4 Serie Breve Descripción página 15

1 User
Valve terminal type CPV..−GE−ASI−4−... has been designed
exclusively for controlling pneumatic actuators and is only
suitable for use in bus systems in accordance with the
AS−Interface specifications. The maximum values specified
for pressures, temperatures, electrical data, torques etc.
must be observed.
AS−Interface bus systems and valve terminals may only be
installed by personnel especially trained for this purpose.
Detailed information on the design and method of addres
sing your AS−Interface bus system can be found in the man
ual for your master.
Detailed information on the pneumatic components of the
valve terminal can be found in the Pneumatics manual
P.BE−CPV−... .
Warning
S Switch off the power supply before connecting or
disconnecting plugs (otherwise this could lead to
functional damage).
S Connect the earth connection on the end plate with
low impedance (short cable with large cross−sec
tional area) to the earth potential.
S Commission only a valve terminal which has been
fitted and wired completely.
Festo CPV..−GE−ASI−... 0802d English
instructionsEnglish
15