Festo CPV GE-ASI-4 Serie Breve Descripción página 23

Please note with branch lines:
the maximum total length of the AS−Interface bus:
100 m (without repeater/extender).
the cable length of the load voltage connection
(depends on the current consumption of the valve
terminal and fluctuations in load voltage).
Pin assignment Bus" (yellow cable):
1
Pin 2: AS−Interface + (brown)
2
Pin 1: AS−Interface − (light blue)
Pin assignment 24 V DC" (black cable):
3
Pin 2: + 24 V (brown)
4
Pin 1: 0 V (blue)
*)
Can be configured via DIP switch, see section 4.2.
For connecting the valve terminal use the Festo cable
sockets type ASI−SD−FK... . You will then comply with
protection class IP65. Proceed as follows:
1. Press the AS−Interface cable into the upper part of the
cable socket.
2. Make sure that the cable is free of tension.
3. If necessary, insert the cable socket or a blanking plug
and screw it tight (max. 0.3 Nm).
Seal open flat cable ends with the Fest cable cap type
ASI−KK−FK or the cable sleeve type ASI−KT−FK. In this way
you will avoid leakage currents and comply with protection
class IP65.
Festo CPV..−GE−ASI−... 0802d English
1
2
3
*)
4
23