Festo CPV GE-ASI-4 Serie Breve Descripción página 21

4.2 Configure the load voltage (additional supply)
Caution
Functional damage
S Switch on the power supply only if the DIP switch is
positioned at a permitted setting (see following
table).
1
DIP switch for
configuring the
voltage supply on
the bottom of the
sub−base
Setting
With load voltage
Supplying the valves via a separate load
voltage connection (additional supply)
Without load voltage
Supplying the valves via the AS−Interface
bus (seal connection 24 V DC" with a
blanking plug type ASI−SD−FK−BL).
1)
black = pressed
Instructions on removing the electric sub−base can be
found in the Pneumatics Manual.
Festo CPV..−GE−ASI−... 0802d English
DIP switch setting
1, 2: Off
3, 4: On
1, 2: On
3, 4: Off
1
1)
21