Impact Cap; Suspension; Ear Cover, Ratchet Cover, And Liner; Headband - MSA Cairns 1010 Manual De Uso

5.3.2
If any of the following conditions exist, replace the impact cap.
5.3.2.1
• Cracks
• Depressions or dents equal to or larger than a thumbnail
• Punctures, blisters, or discoloration due to impact, excessive heat, or normal wear
• Delamination/separation of foam from the black liner
5.3.2.2
• Cracks
• Depressions or dents equal to or larger than a thumbnail
• Punctures, blisters, or discoloration due to impact, excessive heat, or normal wear
• Cracked and distorted (that is, out of round) plastic tube
• Rigid rubber tube (should be supple and elastic)
5.3.3
If any of the following conditions exist, replace the suspension:
• Straps have missing, cut, fraying, or broken stitching
• Straps are torn or abraded
• Straps are brittle or discolored
• Suspension attachment clips are broken, brittle, whited, or discolored
5.3.4
If any of the following conditions exist, replace the applicable part:
• Missing, cut, or broken stitching
• Torn, discolored charred, perforated or seared
• Missing hook-and-loop fasteners for ear cover (excluding MSA Cairns 880 Fire Helmets, which do
not have hook-and-loop fasteners)
5.3.5
If any of the following conditions exist, replace the headband:
US
• Brittle, torn, cracked, or broken
• Holes
• Able to open ratchet by tugging on nape arms (rather than turning the knob)
5.3.6
If any of the following conditions exist, replace the chinstrap:
• Frayed, missing, or broken parts
• Missing, cut, frayed, or broken stitching
• Clogged or worn-out hook-and-loop fastener
• Brittle, broken, or missing quick-release button
• Loose Postman's Slide
• Broken or cracked attachment points
• Loose snap fasteners
18

Impact Cap

Models 1010 and 1044 (Black Impact Cap)
Models 1010 and 1044 (Grey Impact Cap), 660C, 664, HP3, 880, 360R, 360R-
13, and 360S

Suspension

Ear Cover, Ratchet Cover, and Liner

Headband

Chinstrap

MSA Cairns Fire Helmets