MSA Cairns 1010 Manual De Uso página 25

(5) Remove the chinstrap.
(6) Remove the breakaway tabs.
(7) If applicable, do the following:
a) Use a Phillips-head screwdriver to remove the goggle clips or faceshield brackets, then
remove the goggles and/or faceshield.
b) Use an adjustable wrench and Phillips-head screwdriver to remove the NFPA-compliant
Bourke lens.
(8) Remove the impact cap assembly from the shell.
(9) If necessary, do the following to remove the suspension from the impact cap:
a) Unsnap the suspension attachment points from the retaining tabs on the impact cap.
b) Pull the suspension out from the impact cap to remove it.
(10) If necessary, do the following to install the suspension in the impact cap:
a) Install the suspension in the impact cap.
b) Connect the suspension attachment points to the retaining tabs on the impact cap.
c) Pull on the suspension to make sure the suspension attachment points are fully engaged
and secure.
(11) Use a Phillips-head screwdriver to install the four screws that attach the chinstrap and the left
and right breakaway tabs.
(12) If applicable, do the following:
a) Use a Phillips-head screwdriver to install the goggle clips or faceshield brackets, then install
the goggles and/or faceshield.
b) Use an adjustable wrench and Phillips-head screwdriver to install the NFPA-compliant
Bourke lens.
(13) Install the four suspension retainer lugs by pushing down on the lugs. The lugs will click into
place when they are fully engaged.
(14) Install the headband and ear cover.
MSA Cairns Fire Helmets
US
25