Models 1010 And 1044 (Grey Impact Cap) - MSA Cairns 1010 Manual De Uso

5.4.2
1 Shell
2 Cap nuts
3 Washers
4 Left breakaway tab
5 Screws
6 Faceshield
(1)
(2)
(3)
(4)
US
(5)
(6)
(7)
(8)
(9)
(10)
(11)
22

Models 1010 and 1044 (Grey Impact Cap)

1
2
3
11
5
10
Turn the fire helmet upside down.
Remove the ear cover and headband.
Use a Phillips-head screwdriver to remove the four screws that attach the right and left break-
away tabs, washers, and cap nuts to the shell.
If applicable, do the following:
a) Use a Phillips-head screwdriver to remove the goggle clips and/or faceshield brackets, then
remove the goggles and/or faceshield.
b) Remove the Defender visor by squeezing the quick-connect locking arms together and
pulling up.
Remove the impact cap assembly from the shell.
Remove all hook-and-loop fasteners on the inside of the shell and outside of the impact cap.
If necessary, do the following to remove the suspension from the impact cap:
a) Unsnap the suspension attachment points from the retaining tabs on the impact cap.
b) Pull the suspension out from the impact cap to remove it..
If necessary, do the following to install the suspension in the impact cap:
a) Install the suspension in the impact cap.
b) Connect the suspension attachment points to the retaining tabs on the impact cap.
c) Pull on the suspension to make sure the suspension attachment points are fully engaged
and secure.
Install hook-and-loop fasteners on the inside of the shell and outside of the impact cap.
Install the impact cap assembly in the shell.
Do the following on the left and right sides of the fire helmet:
a) Install the breakaway tab, and hold it in position.
b) Install the washer and then the cap nut, and hold them in position.
2
3
4
5
8
9
6
7
7 Defender visor
8 Impact cap
9 Supension
10 Ear cover
11 Right breakaway tab
MSA Cairns Fire Helmets