Initial Installation; Important; Downrod Style Fan Mounting - Harbor Breeze 00830 Manual De Instrucciones

INITIAL INSTALLATION

1. Determine mounting method to use.
A - Downrod Mount (normal or angled ceiling)
B - Closemount (normal ceiling only)
Important: lf using the angle mount, check
to make sure the ceiling angle is not steeper than 20°.
2.
Remove and discard the three rubber inserts and three
mounting screws (I) from the underside of the motor
housing assembly (H).
3. Remove the mounting bracket (A) from the canopy (B)
by loosening the four screws on the top of the canopy
(B). Remove the two non-slotted screws and save, then
loosen the slotted screws. This will enable you to remove
the mounting bracket (A).
1
A
B
2
H
Rubber
insert
3
A
Loosen but
do not remove
Remove
and save
B
Lowes.com/harborbreeze
6
INITIAL INSTALLATION
4. Install the mounting bracket (A) to the outlet
box (not included), sliding the mounting bracket (A) over
the two outlet box screws (not included). Securely tighten
the two outlet box screws.
IMPORTANT: If using the angle mount, make sure
open end of mounting bracket (A) is installed facing the
ceiling.
Follow mounting instructions for "Downrod Style
Fan Mounting" or "Closemount Style Fan
Mounting" depending on mounting method (A or
B) chosen in Step 1 on previous page.

DOWNROD STYLE FAN MOUNTING

1. Remove pin and clip from downrod assembly
(E) and save.
I
2. Insert downrod assembly (E) through canopy (B),
canopy cover (C) and yoke cover (D). Thread wires
from the motor housing assembly (H) through downrod
(E).
4
outlet box
1
clip
pin
2
B
E
D
Lowes.com/harborbreeze
7
A
E
C