Closemount Style Fan Mounting - Harbor Breeze 00830 Manual De Instrucciones

DOWNROD STYLE FAN MOUNTING
3. Loosen the two set screws from the yoke. Slip downrod
assembly (E) into yoke, aligning holes in downrod
assembly (E) and yoke. Insert the pin through yoke and
downrod assembly (E). Insert clip into pin until it snaps
into place. Tighten set screws. Slide the yoke cover (D)
down over the motor housing (H).
4. lnstall hanger ball on the top of downrod (E) into
mounting bracket (A) opening. Rotate fan until slot on
hanger ball engages the tab on the mounting bracket
(A).
Warning: Be carefully when aligning the tab to the slot!
If not fully engaged, there is a possibility of fan falling,
which may result in serious injury or death.
You may now proceed to the WIRING section on
page 10.

CLOSEMOUNT STYLE FAN MOUNTING

1. Remove the canopy cover (C) from the bottom of the
canopy (B).
3
E
D
clip
set screw
pin
4
tab
A
E
1
B
Lowes.com/harborbreeze Lowes.com/harborbreeze
8
CLOSEMOUNT STYLE FAN MOUNTING
2. Remove every other screw from the top of motor
housing (H) and save.
H
3. Place the rubber gasket (DD) over the remaining
screws. Pull wires through hole in canopy (B), and
attach canopy (B) to motor housing (H). Align the
mounting holes with the holes in the motor and fasten
using the three screws removed in previous step.
Tighten the screws securely.
slot
Hardware Used
Rubber gasket
DD
4. Hang the fan on the hook on the mounting bracket (A)
using one of the non-slotted holes in the canopy (B).
C
2
H
3
H
DD
x 1
4
hook
B
Lowes.com/harborbreeze Lowes.com/harborbreeze
9
B
A