Mettler Toledo PANTHER Guia De Instalacion página 17

Note: When the cover swings down, the terminal strips on the Controller PCB can be
seen. (See Figure 6.) You will make the electrical connections using these terminal
strips. Note: The PCB will be upside down.
TB3
6. Pass the cables that enter the enclosure through an appropriately sized cable
grip before connecting the wires.
7. Make the required electrical connections per the instructions in the section
entitled Electrical Connections.
8. Re-secure the back cover.
9. Tighten the cable grip to provide a water-tight seal around the cable. This will
allow any internal cable slack to be received through the cable grip.
10. Push the bottom of the front cover over the enclosure. A snap sound indicates
that the cover is in place. Squeeze the front cover to the enclosure at all four
corners to verify that all four clips are properly engaged.
Accessing the Terminal's Controller PCB
TB2 TB1
Figure 6
Chapter 1: Introduction
(7/03) 1-7