Replacement Parts - Mettler Toledo PANTHER Guia De Instalacion

METTLER TOLEDO PANTHER Panel-Mount Terminal Division 2 Installation Guide

Replacement Parts

3-2 (7/03)
If a failure occurs in a PANTHER panel-mount terminal that is installed in a Division 2 area,
note that only certain revisions of some components may be used as replacements. The
following parts must be at least the letter revision indicated (or newer) to be installed on a
Division 2 PANTHER panel-mount terminal. A newer revision of a part number with a 'D"
revision would begin with the letter 'E', 'F', 'G', etc.
PANTHER Main PCB
Profibus PCB
Keyboard Overlay
IF THE KEYBOARD, DISPLAY LENS OR ENCLOSURE IS DAMAGED
ON A PANTHER PANEL-MOUNT TERMINAL THAT IS USED IN AN
AREA CLASSIFIED AS DIVISION 2, THE DEFECTIVE COMPONENT
MUST BE REPAIRED IMMEDIATELY. REMOVE AC POWER AND
DO NOT REAPPLY AC POWER UNTIL THE DISPLAY LENS,
KEYBOARD OR ENCLOSURE HAS BEEN REPLACED BY QUALIFIED
SERVICE PERSONNEL. FAILURE TO DO SO COULD RESULT IN
BODILY HARM AND/OR PROPERTY DAMAGE.
'D'15201500A
'A'15166100A
'E'14828300A
WARNING