Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Original parking distance control system, Polo 2009 ➤
Set contents:
◆
1 x controller
◆
1 x buzzer
◆
4 x sensor
◆
4 x covering rings
◆
1 x fixing material
Special tools, test and measuring equipment, and ancillaries required:
◆
Torx Allen keys (set)
◆
Flat-bladed screwdriver
◆
Side cutters
◆
Hand drill
◆
Set of twist drills
Forstner bit ∅ 20 mm
◆
◆
Expanding/crimp grip pliers
Procedure:
Note
◆
The original parking distance control system should be fitted by a competent workshop. Incorrect fitting may lead
to damage to the vehicle or the parking distance control system.
◆
The original parking distance control system is not suitable for being fitted in vehicles with subsequent lowering
(sport suspension, etc.).
◆
The work to be performed described in these fitting instructions may change due to model servicing schedules.
For example, changes to the wiring colours or even the fitting sites should not be discounted. For this reason,
always consult the relevant up-to-date wiring diagram or the current vehicle repair manual.
◆
All rights to make technical changes reserved.
1.1 Paint sensors
Note
◆
Do not clean the sensors prior to painting with a silicone remover, but use a mild alcohol, e.g. methylated spirit
◆
Leave the sensors for painting in the packaging supplied, this is provided as a painting device.
◆
Additional general information concerning painting:
Self-study programme No. 214/215
Page 1 - figure 1
The figure gives an example of the protective rings -1- already placed in the correct position on the sensors -4-.
Place the covering rings -2- on the rubber membranes of the sensors -3-.
Paint the sensors -3- and -4- evenly and not too thickly, in the same colour as the car.
Remove the covering rings -1- and -2- carefully directly after painting (while the paint is still wet) using tweezers
and let the paint dry.
Note
The protective rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.
Repaint as necessary after drying (e.g. clear lacquer for twin coat painting).
1.2 Fitting the components
Page 2 - figure 2
Apply masking tape liberally in the areas where the holes are to be drilled in order to protect the bumper covering.
Remove the bumper covering.
Exterior bodywork tasks; Repair Group 63; bumper; rear bumper; removing and refitting the bumper covering
Page 2 - figure 3
Inside the bumper covering are four circle markings to permit mounting of the sensors. The drilling positions are the
centre points of these circles.
Draw the drilling spots on the inside of the bumper covering and center punch the drilling points.
Pre-drill the holes using a ∅ 2 mm drill bit.
Use a ∅ 20 mm Forstner bit to drill the holes from the outside.
◆
1 x power harness
◆
1 x sensor harness
◆
1 x installation instructions
◆
1 x operation manual
◆
Triangular file
◆
Round file
◆
Measuring and cutting tool
◆
Centre punch
◆
Tweezers
◆
-VAS 1978- wiring harness repair set
19
Publicidad
