Important Remarks - Zhermack freealgin Manual De Instrucciones

STORAGE
Impressions made with Freealgin must be kept at room temperature. Freealgin impression ma-
terials are guaranteed for 3 years following the date of production provided they are kept at a
temperature of between 5° and 27°C / 41°- 80°F.
GALVANISATION
Freealgin impressions may be galvanised with copper or silver.
ISO 4823 / ADA Spec. 19
Mixing ratio Base : Catalyst
Mixing time
Total working time*
Time in mouth (minimum)
Setting time*
Strain in compression (min - max)
Recovery from deformation
Linear dimensional variation after 24h
Hardness "Shore A"
*The times mentioned must be intended from the start of mixing at 23°C – 73°F. Higher tempera-
tures reduce the times, lower temperatures increase them.
IMPORTANT REMARKS: Consulting services on the use of our products, provided in any form, be that verbal, written
or through demonstrations, are based upon the current state of dentistry and of our know-how. They are to be
considered as non-binding information, also in relation to possible third party claims, and do not exonerate the user
from personally checking whether the product is suitable for the planned use. Use and application by the user take
place under no possible control by the Company, and are therefore under the user's responsibility. Possible liability for
damages is limited to the value of goods supplied by the Company and utilized by the user.
freealgin
freealgin maxi
Type 2 Medium-Bodied Consistency
1:1
5:1
Auto mixing System
1'
1' 30''
2' 30''
3 – 5 %
> 99,5 %
< 0,20 %
40
FOR DENTAL USE ONLY