2.2 S
D
AFETY
EVICES
This water cleaner is provided with the following safety devices:
a) Thermal protector
It's a device that stops the water cleaner operation in case of motor overheating.
In this case, proceed as follows:
• switch the main switch (2) to position "0" and remove the plug from the power outlet;
• press the lever (26) on the cleaner gun to eliminate any remaining pressure;
• wait 10 to 15 minutes until the water cleaner cools down;
• check that the instructions in the "CHECKS AND CONNECTION TO THE MAINS ELECTRICITY
SUPPLY"
section have been followed, particularly regarding any extension cord used;
• replace the electric plug in the power outlet and repeat the start-up procedure described in the
" OPERATION " section.
WARNING
• If this safety device cuts in repeatedly, do not use the water cleaner until it has been checked by a Skilled
Technician.
b) Pressure limit/adjustment valve
When this valve has been correctly set, the pumped fl uid is able to return to the pump's suction unit, thus
preventing the creation of dangerous levels of pressure when the cleaner gun is stopped or should pressure
be set that is above allowed levels.
c) Safety stop on cleaner gun lever
This is a safety catch (25) which, when pressed, lets you block the lever (26) on the cleaner gun (14) to
prevent the possibility of it being started by accident (see also Fig. 4, pos. S)
2.3 I
U
NTENDED
SE
WARNING
• This water cleaner is to be used exclusively for:
- cleaning vehicles, machinery, buildings, tools etc with cold water, possibly with the addition of detergents
as per the Manufacturer's instructions;
- distributing detergents as per the Manufacturer's instructions;
- removing lime scale and unblocking pipe work using the appropriate tools as per the Manufacturer's
instructions;
- water sanding objects using the appropriate tools as per the Manufacturer's instructions;
• The water cleaner must not be used to wash people, animals, energized electrical appliances, delicate
objects or the high pressure cleaner itself.
• The high pressure cleaner is not suitable for use in certain situations such as in corrosive or explosive
atmospheres.
• Contact the Manufacturer's service centre before use on board vehicles, ships or airplanes, as there may
be additional instructions for use.
Any other use is considered improper.
The Manufacturer is not liable for any damage caused by improper or incorrect use.
3 R
T
EMOVING
HE
WARNING
• Protective gloves and glasses must be worn when removing the appliance from the packing materials to
prevent injury to the hands and eyes.
• The packing materials (plastic bags, staples etc.) must not be left in reach of children, as they are potentially
dangerous.
• The packing materials must be disposed of according to current regulations in the country where the water
cleaner is installed.
In particular, plastic bags and packaging must never be abandoned, as they are harmful to the
environment.
20
A
F
PPLIANCE
ROM
I
P
M
TS
ACKING
ATERIALS