CAMPAGNOLO ZONDA Manual Del Usuario página 33

4) If installing the sprockets without the plastic
support, install the individual or preassembled
sprockets and the spacers on the sprocket body of
the hub aligning the spline patterns (Fig. 28). The
profile of the freewheel body with two asymmetri-
cal grooves (Fig. 28) ensures automatic sprocket
timing since there is only one assembly option.
5) Using a torque wrench (D - Fig. 29) equipped
with Campagnolo tool UT-BB080 (B - Fig. 29),
®
tighten the lockring (G - Fig. 29), which is provi-
ded with the Campagnolo sprockets, on to the
freewheel body to 40 Nm (354 in.lbs).
4.2.2 - DISASSEMBLY
1) Remove the lockring (G - Fig. 30) using the
Campagnolo tool UT-BB080 (B - Fig. 30) with a 24
®
mm hexagonal wrench (E - Fig. 30) and the chain
whip Campagnolo UT-CS060 (F - Fig. 30).
®
2) Insert the plastic sprocket carrier on the side of
the freewheel body and align the spline patterns
on the body with those on the carrier. Slide the
sprockets onto the carrier.
3) Slide the sprockets, off the freewheel body
(Fig. 31).
14
28
E
E
F
F
UT-CS060
UT-CS060
APRIRE
OPEN
OPEN
ÖFFNEN
30
G
C
UT-BB080 UT -BB080
B
B
29
C
G
B
B
UT- BB080
UT-BB080
31
D
D
40 Nm
(354 in.lbs) 40 N.m - 29.5 lb.ft
CLOSE