Operation Warnings - Tripp-Lite PowerVerter Plus PV 500FC El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety
This manual contains important instructions and warnings that should be followed during the
installation, operation and storage of all Tripp Lite PowerVerter Systems.
PowerVerter Location Warnings
• Install your PowerVerter indoors, away from excess moisture or heat, dust or direct
sunlight.
• Do not attempt to mount your PowerVerter on a vertical surface.
• Leave adequate space around all sides of the PowerVerter for proper ventilation. The
more power connected equipment draws, the more heat will be generated by the
PowerVerter.
• Do not install the PowerVerter near magnetic data storage media, as this may result in
data corruption.
Battery Connection Warnings
• Your PowerVerter will not operate until batteries are connected.
• Multiple battery systems must be made up of batteries of the same voltage, age, amp
hour capacity and type.
• Keep battery location well ventilated. Explosive hydrogen gas can accumulate near
batteries if they are not kept well ventilated.
• Sparks may result during final battery connection. Always observe proper polarity as
batteries are connected.
• Tighten your battery terminals to create an efficient battery connection and prevent
excessive heating.
• Do not allow objects to contact the two DC input terminals. Do not short or bridge these
terminals together. Serious injury to property or person could result.
Equipment Connection Warnings
• Do not use Tripp Lite PowerVerter Systems in life support applications where a
malfunction or failure of a Tripp Lite PowerVerter System could cause failure or
significantly alter the performance of a life support device.
• Do not connect a surge suppressor, line conditioner or UPS to the output of the
PowerVerter.

Operation Warnings

• Your PowerVerter does not require routine maintenance. Do not open your PowerVerter
for any reason. There are no user-serviceable parts inside.
• Potentially lethal voltages exist within this unit as long as the batteries are connected.
During any service work, the batteries should therefore be disconnected.
• Do not connect or disconnect batteries while the PowerVerter is operating. Dangerous
arcing may result.
2

Publicidad

Tabla de contenido
loading

Tabla de contenido