Operation; Indicator Lights - Tripp-Lite PowerVerter PV1000HF Manual Del Propietário

Ocultar thumbs Ver también para PowerVerter PV1000HF:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

Switch Modes
Switch between the following operating modes as appropriate to your situation:
"ON": Switch to this
setting to provide
connected equipment
with AC power.

Indicator Lights

Your Inverter is equipped with a simple, intuitive, user-friendly set of indicator lights. These easily-remembered "traffic
light" signals will allow you, shortly after first use, to tell at a glance the charge condition of your batteries, as well as
ascertain approximate equipment load level.
"BATTERY" Indicator Lights: These three lights will
illuminate in several sequences to show the approximate
charge level of your connected battery:
Approximate Battery Charge Level
Indicator Illuminated
1
Green
2
Green & Yellow
3
Yellow
4
Yellow & Red
5
Red
6
Flashing Red (slowly)*
7
Flashing Red (quickly)** 0% (Inverter
"OFF": Switch to
this setting to shut
down the Inverter
completely, preventing
it from drawing power
from the batteries. Use this switch to
automatically reset the unit if it shuts
down due to low battery or overload.
Use an optional remote control module
(Tripp Lite model APSRM4, sold
separately or included with PV3000HF
models) to reset unit due to overload
only.
Battery Capacity
91%–Full
81%–90%
1
2
61%–80%
41%–60%
21%–40%
1%–20%
4
5
has shutdown)
7
"LOAD" Indicator Lights: These three lights will illuminate
in several sequences to show the approximate equipment
load level on the Inverter's AC receptacles.
Approximate Equipment Load Level
Indicator Illuminated
1
Green
2
Green & Yellow
3
3
Yellow
4
Red
5
Flashing Red (quickly)** OVERLOAD
6
† Charge levels listed are approximate. Actual conditions vary
depending on battery condition and load. * Approximately
½ second on, ½ second off. ** Approximately ¼ second on,
¼ second off. See "Resetting Your Inverter to Restore AC Power"
to reset after Inverter shut down.
5
"REMOTE": Switch to
this setting to remotely
monitor and control the
Inverter with the use
of an optional remote
module. See remote module's owner's
manual for operating instructions.
Load Level
0%-50%
51%-75%
76%-90%
1
> 90%
(Inverter has
4
shutdown)
2
3
5

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Powerverter pv1800hfPowerverter pv3000hf

Tabla de contenido