Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000070-002.book Page 13 Thursday, July 24, 2014 11:37 AM
Working instructions.
Secure the power tool with the safety strap supplied at all times, especially for
WARNING
work carried out at elevated heights, when drilling horizontally or above the
head. If there is a power loss, or the power plug is pulled out, the magnetic holding power is
not maintained.
Fastening the safety strap (figure 6).
Fasten the machine securely around the
workpiece using the provided safety strap.
For switching the magnet ON
(figure 7).
Please make sure that the contact surface-
for the magnetic base is level, clean and
rust-free. Remove any varnish or primer.
When working, always use the magnetic
base; ensure that the magnetic holding
power is sufficient.
When working on materials that are non-fer-
rous, suitable fixation devices obtainable as
accessories from the manufacturer, e. g. suc-
tion plates, vacuum plates or pipe-drilling
devices must be used.
When working on steel materials with a
material thickness of less than 12 mm /
the workpiece must be reinforced with an
additional steel plate in order to guarantee the
magnetic holding power.
Press the magnet switch to energize the mag-
net.
1
/
in,
2
en
13
Publicidad
