Siemens SIMATIC NET SCALANCE X-300 Manual De Configuración página 399

Ocultar thumbs Ver también para SIMATIC NET SCALANCE X-300:
Tabla de contenido

Publicidad

● C-PLUG removed at runtime.
● C-PLUG plugged in at runtime.
● RMON rising alarm occurred.
● RMON falling alarm occurred.
● Ring redundancy enabled.
● Ring redundancy disabled.
● (R)STP protocol enabled.
● (R)STP protocol disabled.
● Disabled (R)STP because ring redundancy is enabled.
● DIP settings taken from C-PLUG.
RM=<ON|OFF>, STBY=<ON|OFF>, R1=<ON|OFF>, R2=<ON|OFF>
● (R)STP topology change detected while (R)STP is off. Aging time will be reduced to
<tiempo en s> sec for at least <tiempo en s> sec.
● Set aging time back to original value <tiempo en s> sec.
● No connection to SNTP server. Server IP address <dirección IP>.
● Connected to SNTP server. Server IP address <dirección IP>.
● Enabled link status monitoring on ring ports.
● Changed port VLAN ID of the ring ports to 1.
● Disabled GVRP because ring redundancy is enabled.
● Disabled GMRP because ring redundancy is enabled.
● Disabled mirroring because monitor port is ring port.
● (Re)enabled ring ports (because disabled by user).
● Disabled port lock on ring ports.
● Warning: ring ports have different static VLAN configuration.
● Warning: ring ports have different VLAN port configuration.
● Warning: ring ports have different static multicast configuration.
● Warning: ring ports have different load limits configuration.
● Enter fault state: port <número de puerto> enabled for link status monitoring and link
down.
● Leave fault state: port <número de puerto> disabled for link status monitoring.
● Enter fault state: power line <ID de la fuente de alimentación> enabled for power
monitoring and power down.
● Leave fault state: power line <ID de la fuente de alimentación> disabled for power
monitoring.
● <CLI | WBM | SSH>: Authentication failure.
● Warning: OSPF consumed too much memory and is shut down.
● Duplicate IP address <dirección IP> sent from <dirección MAC>
SCALANCE X-300 / X-400
Manual de configuración, 03/2015, C79000-G8978-C187-23
D.1 Mensajes de error del SCALANCE X300 / X400
Anexo D
399

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Simatic net scalance x-400

Tabla de contenido