Insert Cards In The System Boxes - Bosch SBH301 Manual De Instrucciones

3 609 929 816/2009-02 | SBH.../SB...
5 Commissioning
5.3 Insert cards in the system
boxes
The individual assemblies (SE3x1 / SE3x2 /
KE3xx...) should be inserted into the system
boxes with the following drawings.
*Tightening channel:Tightening system controlg SE3xx
+
servo amplifier LT30x/LTU350
or
controller for hand-held nutrunner
SEH3x2
+
servo amplifier LTH12 (external)
Figure 4: SB305
slots for the various components
Tightening system control SE3xx
+
servo amplifier LT30x/LTU 350
or
controller for hand-held nutrunner
SEH3x2
+
servo amplifier LTH12 (external)
or
KE300/310/312
VM300
Figure 5: SB301
slots for the various components
The slots .1 - .5 can be equipped with a tigh-
tening channel (LT30x/LTU350, SE3xx),
SEH3x2 controller for hand-held nutrunner or
the KE3xx.
In order to ensure a uniform system configu-
ration in the field, we recommend that the
KE3xx be inserted in the slot 5 (SB305) or
slot 1 (SB301) of the system box with the
Tightening channel*
lowest address.
or
Up to 16 system boxes can be connected to-
KE300/310
gether in one tightening system. A maximum
of up to 40 tightening channels can be in-
stalled with a KE3xx without a switch cabinet.
Tightening channel*
The following block diagram provides an
overview of the Tightening System 300 with-
VM300
out switch cabinet.
Bosch Rexroth AG 35/148