Regular Maintenance - Maruyama BC360HT Manual Del Propietario - Operador

REGULAR MAINTENANCE

AIR FILTER
The air filter should be cleaned each time the brushcutter is used. (Or more often with extreme conditions.)
Remove the filter cover and take out the element. Wash the element in kerosene or warm detergent, then
squeeze it dry. Apply oil (#30 wt.) to foam, removing all excess oil. Assemble and reinstall the element and
filter cover.
Air Filter Cover
Knob
[BC360HT, BC360HE]
SPARK PLUG
The spark plug should be removed from the engine and
checked after each 25 hours of operation. The tips can be
cleaned with a stiff brush.
Adjust the gap to 0.6-0.7mm (see sketch). Replace the spark
plug if it is oil fouled or damaged, the average spark plug life
is approximately 100 hours.
CAUTION-Do not over tighten the spark plug. The correct
torque is 10.7-16.6N • m(100 -160 kgf • cm).
CYLINDER COOLING FINS
1. Remove the air filter cover.
2. Remove the plug cap.
3. Loosen the knob and lift off the top cover. Clean all dirt and debris from the cooling fins and from around
the cylinder base. Reinstall the top cover and the air filter cover.
Top Cover
Plug Cap
Air Filter Cover
[BC360HT, BC360HE]
Element
Knob
Cooling Fine
＿ US-9 ＿
Filter Cover
Foam Element
[BC420HE]
0.6-0.7mm
Top Cover
Knob
Cooling
Fins
[BC420HE]
Plug Cap
Cooling
Fins