Hot Restart - Maruyama BC360HT Manual Del Propietario - Operador

Starter Grip
Primer Bulb
Primer Bulb

HOT RESTART

To start the engine that is already warmed up (hot restart):
1. Pump the primer bulb until fuel can be seen flowing through
the fuel return line. (Flowing fuel should be almost clear, not
foamy or full of bubbles.)
2. Turn the choke lever to the "OPEN" "
stop switch to the " /ON" position.
3. Leave the throttle trigger in the idle position and pull the starter
grip.
4. If the engine fails to start after three to four pulls, follow the
instructions in the Cold Starting Procedure section above.
If the engine fails to start after you follow the above proce-
dures, contact an authorized MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle trigger.
2. Slide the stop switch to "
Choke Lever
[BC360HT, BC360HE]
Fuel Return Line
" position, and set the
/OFF" position.
＿ US-7 ＿
Starter Grip
Choke Lever
[BC420HE]
Throttle trigger
Fuel Return
Line
Stop Switch
/OFF
/ON