Dust Extraction; Service And Maintenance; Environment - Festool EAA Manual De Instrucciones Original

EAA
GB
11.4

Dust extraction

WARNING
Dust hazard
Dust can be hazardous to health. Always
work with a dust extractor.
Always read applicable national regula-
tions before extracting hazardous dust.
If national safety regulations stipulate that
dust extractors must have a suction power
monitoring function (volumetric flow moni-
toring), only one extractor opening [1-8] on
the EAA can be opened.
Version CT/SRM/M
The slide [1-10] ensures that only one ex-
tractor opening is open and the other one is
closed so that the dust extraction system
only operates with one machine. You can de-
cide which extraction opening to use by
changing the position of the slide.
Version TURBO/M
When extracting non hazardous dust, the
TURBO/M version can operate and extract
from two machines at the same time.
Version TURBO/A
The EAA detects which tool is operating and
opens the corresponding extractor opening
automatically. The simultaneous operation
and extraction of two machines is also possi-
ble.
Only the right extractor connector is oper-
ational when the rotary switch [1-4] is
set to "MAN" .
12

Service and maintenance

WARNING
Risk of accidents
Disconnect the EAA/ASA from the power
and compressed air supply before per-
forming any maintenance and repair work.
All maintenance and repair work on the
electrical or electronic system must al-
ways be carried out by a qualified electri-
cian.
24
Customer service and repair
only through manufacturer or
service workshops: Please find
the nearest address at:
www.festool.com/Service
Use only original Festool spare
EKAT
4
parts! Order No. at:
www.festool.com/Service
5
3
2
1
12.1 Adjusting the lubricator
Set the pressure regulator [2-1] to a flow
pressure of 0 bar. Note: the entire service
unit must be depressurised!
Unscrew the oil vessel [2-6].
Fill the oil vessel 3/4 full with special oil
(481722).
Screw the oil vessel back on.
Set the pressure regulator to a flow pres-
sure of 6 bar before operating a pneumat-
ic tool.
Make sure that the vent screw [2-2] is
closed.
Screw the adjusting screw [2-4] in the
viewing window all the way in.
Then unscrew the adjusting screw ap-
prox. 1/4 of a turn.
Observe the oil drops in the viewing win-
dow [2-3] while the pneumatic tool is op-
erating.
Set the adjusting screw so that one drop
of oil escapes every 10-20 minutes.
Screw the condensate screw [2-8] all the
way in.
13

Environment

Do not dispose of the device in
household waste! Recycle de-
vices, accessories and packaging.
Observe applicable country-spe-
cific regulations.
EU only: European Directive 2002/96/EC
stipulates that used electric power tools must
be collected separately and disposed of at an
environmentally responsible recycling cen-
tre.
Information on REACh:www.festool.com/
reach