AERMEC VMF-RCC Manual Del Usuario página 113

E5 panel technical specifications
1 Date
MZC PLENUM ADDRESS SETTINGS
For MZC plenums to properly communicate with the system controlled by VMF-RCC, the
modbus address and baud rate must be set in the respective ADS and BDS parameters in the
MZCUI master interface; below is an extract from the manual describing the serial
communication parameters:
ADS (PASS: 22)
The ADS parameter is the modbus address of the MZC board (serial slave) for connection to supervision or
control systems. This parameter can include values from 0 to 253, where 0 indicates that the supervision serial
line has not been enabled.
BDS (PASS: 22)
The BDS parameter identifies the baud rate of the supervision serial line, specifically:
Specifically:
09/08/2017 Author
Fig. 1 Supervision serial port
BDS = 0 → 9600bit/s
BDS = 1 → 19200bit/s
BDS = 2 → 38400bit/s
MZC index ADS BDS
MZC 1
MZC 2
MZC 3
F. Carpanese
30 1
31 1
32 1
Code
Type indoor
RS485
supervision
serial port
2104_2696105_00
113