Cautions And Warnings - Buffalo filter VisiClear Manual Del Operador

12. This equipment utilizes mobile RF communications equipment that can affect medical
electrical equipment.
13. This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at their expense.
14. This equipment operates in the following radio frequency specifications:
RX modulation: Pulse-width coded, AM 100% modulation
TX Frequencies: Manchester encoded,
A = fc =/- 423.75kHz, B = fc +/- 484.29kHz
Low bit: transition A to B
High bit: transition B to A
15. To isolate equipment from supply mains, unplug the power cord from the appliance inlet
on the unit or receptacle in the wall. Position the equipment to allow for ease of unplugging
power cord.
16. Potential Equalization Conductor: Terminal located on back panel for connection of
potential equalization. Conductor complies with requirements per IEC 60601-1 (2005).
The VisiClear™ Surgical Smoke Plume Evacuator(s) and all filters are not intended for contact
with patients.

1.4 Cautions and Warnings

Please note that all Cautions and Warnings should be read and understood before any
use of this equipment.
This device does not have any contradictions for use.
Buffalo Filter® VisiClear™ Operator's Manual
Please note that all Cautions and Warnings should be read
and understood before any use of this equipment.
6