Section 5 System: Service; General Maintenance - ESAB Cutmaster 40 Manual De Instrucciones

5.01 General Maintenance

Warning!
There are extremely dangerous voltage and power levels present inside
this product. Do not attempt to open or repair unless you are a qualified
electrical tradesperson and you have had training in power measurements
and troubleshooting techniques. If major complex subassemblies are faulty,
then the Cutting Power Source must be returned to an Accredited Service
Provider for repair.
Visually inspect the torch body tip,
electrode, start cartridge and shield cup
Replace all
broken parts
Art # A-12778
300X5394

SECTION 5 SYSTEM: SERVICE

Visual check of
torch tip and electrode
Visually check and
Carefully clean the
interior
5-1
Each Use
Weekly
Visually inspect the
cables and leads.
Replace as needed
3 Months
Clean
exterior
of power supply
6 Months
ESAB CUTMASTER 40
Maintain more often
if used under severe
conditions
SERVICE