Serpento FORZA 150 Manual De Usuario página 92

• FORZA 150
MANUAL DEL USUARIO
1 Press the electric starting button for ignition. Never rotate the accelerator grip when pressing the starting button.
Note:
After engine ignition, immediately release the starting button, to avoid adverse effects to the engine.
If the engine is not started after 5 seconds, wait for 10 seconds before making another attempt to prevent damaging the battery.
In case of failure in engine starting after two or three attempts, rotate the accelerator grip for 1/8 or 1/4 turns and try again.
A motorcycle not used for a long time and poor atomizing fuel may result in starting difficulty. In this case, do not rotate the accelerator grip,
but repeat starting.
2 Starting with the kickback start lever
When the battery is over discharged, the engine can be started by using the kickback start lever.
Turn the ignition switch to ON position.
Forcefully kick the kickback start lever.
Cold engine
Put the carburetor enrichment handle (plunger carburetor) or lever (vacuum carburetor) to the highest position (plunger) or pull it fully out
(vacuum carburetor), keep the accelerator closed, and press the electric start button; After the engine is started, press the handle half way
down (plunger) or push the lever half way in (vacuum) and wait for the engine is adequately warmed-up, before putting the handle or lever to
the original position. The colder it is, the longer warm-up time the engine takes. Otherwise, the acceleration may be poor.
29