Connecting The 3G4000W; 3G4000W Operating Modes; Status Leds; Red Led In Normal Mode - Johnson Controls tyco 3G4000W Manual

Table 2: Identifying the parts of the 3G4000W communicator
Number Parts
10 PC-Link connector
11 Battery connector
12 Terminal blocks
13 Cable entry
14 7.2 V - 2.2 Ah battery (optional)
15 Cable run knockout
Note: Use only DSC provided antenna.

Connecting the 3G4000W

TIP (1) / RNG (2) External Telephone Line: If the 3G4000W is being used as a back-up
communicator, connect the terminals directly to the incoming telephone line.
T1 (3) / R1 (4) Internal Telephone Line: These terminals must be connected to the TIP and RING of
the control panel.
Zone 2 (7) Programmable Input: Set up this terminal to trigger events. For more information, see
3G4000W inputs.
PGM2 (8) Programmable Open-collector Output: This output can be activated by programmed
events. For more information, see . The maximum current sink of each output must not exceed 50
mA.
DC in + (9), DC in - (10) Device Power Supply: Connect the terminals to a rated power supply. After
the connections are completed, connect the battery, [12] in Figure 1 to a 7.2 V, 2.2 Ah battery.
Note: When disposing of batteries, follow the instructions and precautions printed on the
batteries, and contact your municipal offices for information on the disposal of used batteries.

3G4000W operating modes

The 3G4000W has two operating modes:
• Normal mode: The 3G4000W communicator is in normal mode when both the cover and the wall
tamper are in a restored state.
• Service mode: If a cover tamper is present, the 3G4000W communicator is in service mode.

Status LEDs

The 3G4000W interface has four status LEDs.
Note: The top two LEDs blink during the initializing and programming phases.

Red LED in normal mode

In Normal mode, the red LED indicates a trouble condition. The following table describes the type
of trouble condition that the number of flashes represent.
12 3G4000W 3G (HSPA) WIRELESS ALARM COMMUNICATOR INSTALLATION MANUAL 5.0