Description; Performance; Installing The 3G4000W - Johnson Controls tyco 3G4000W Manual

Table 1: 3G4000W Technical specifications
Simulated Telco Loop Specifications (TIP/RING)
On-Hook Voltage
Off-Hook Current
Loop Resistance
Loop Current

Description

This equipment (3G4000W) is fixed and is to be installed by Service Persons only (Service Person
is defined as a person having the appropriate technical training and experience necessary to be
aware of hazards to which that person may be exposed in performing a task, and of measures
available to minimize the risks to that person or other persons). It is to be installed and used
within an environment that provides the pollution degree max 2, over voltages category II, in non-
hazardous, indoor locations only. This manual is to be used with the Installation Manual of the
relevant alarm control panel. All instructions specified within that manual must be observed.
This 3G4000W manages transmissions to a central station and can simulate the landline in the
event of trouble (e.g., landline down) or even substitute the landline completely in areas where the
3G or 2G wireless service is provided and a landline is not available. The 3G4000W can communicate
alarm signals using the cellular data network. This capability ensures a fast, reliable path to
central stations equipped with a SurGard SG-System I-IP / II / III / IV / 5 Receiver. By connecting a
3G4000W to a control panel's standard PSTN interface, telephone based Contact ID or SIA signals
are decoded and seamlessly routed through the cellular network to any of the compatible receiver
options.

Performance

The performance of the 3G4000W depends greatly on wireless network coverage. Therefore, it is
not to be permanently mounted without first performing placement tests to determine the best
location for reception. The minimum status LED indication for signal strength is one green or yellow
LED being on. Activate the SIM card prior to performing a placement test to ensure results are
specific to the home network determined by the SIM card.
Optional antenna extension kits – LTE-15/25/50ANT (15ft/4.6m, 25ft/7.6m or 50ft/15.2m) – are
available.
Power the 3G4000W using a compatible listed control unit or compatible listed power supply that
complies with the specified ratings. The power supply is to be listed for burglary applications
and provide a minimum of 4 hours standby power capabilities. An example of a suitable listed
compatible control unit is the DSC Model PC1864 with an AUX output rated 11.1 - 12.6VDC. An
example of a suitable, listed power supply is DSC Model PC5204 with an AUX output rated 11.6 -
12.6VDC.

Installing the 3G4000W

To install the 3G4000W, complete the following procedures:
1. Activating the SIM
2. Creating a new account within the downloading
3. Initializing the receiver.
4. Mounting the 3G4000W.
8
3G4000W Technical specifications
card.
3G4000W 3G (HSPA) WIRELESS ALARM COMMUNICATOR INSTALLATION MANUAL 5.0
12 VDC
24 mA
600 Ohms
25 mA
software.