Kit Assembly - Metra 99-6523 Instrucciones De Instalación

1. Position the radio mounting brackets
into the sub dash opening and secure
with the (2) Phillips screws removed in
disassembly. (Figure A)
2. Attach the (4) panel clips to the radio
trim panel. (Figure B)
3. Mount the pocket to the radio brackets
with (2) #8 x 3/8" screws supplied.
Note: Pins on brackets will align with
front mounting hole of pocket. (Figure C)
(Figure A)

KIT ASSEMBLY

(Figure B)
(Figure C)
4. Attach the radio bracket/pocket
assembly to the aftermarket radio using
the screws supplied with the radio or
the supplied (4) Phillips screws.
Note: Screws must not protrude from
slot in radio brackets as interference
with mounting bracket will occur when
sliding radio into mounting brackets.
(Figure D)
5. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Test the unit for proper
operation.
6. Slide the aftermarket radio/pocket
assembly into the radio opening
between the radio mounting brackets
until it clips into the opening. (Figure E)
7. Snap the radio trim panel into
the opening around the aftermarket
radio to complete the installation.
(Figure D)
(Figure E)
REV. 8/5/2020 INST99-6523
3