Nogueira HAYNOG-300 Manual De Instrucciones página 12

Verify the lower arms of the tractor and make
sure they are the same height as the machine
before coupling it.
Carefully approach the tractor to the machine:
1- First connect the left arm.
2- Then connect the right arm.
3- Finally, connect the upper arm. (the third
connecting point).
Use the hole which is most appropriate to the
length of the connecting arm.
Lack the arms using the pins and respective
locking pins.
After connecting to the tractor, left and fasten
the support foot to the locking pin.
12
Instructions Manual
PLACING THE DRIVESHAFT
CAUTION
Never use the driveshaft without the safety
shielding.
Contact with the moving driveshaft can
cause a serious accident.
Depending on the tractor used, it may be
necessary to cut the driveshaft. This is due to
the variation in distance between the power
take-off and the machine actuation axle, as
there are differences among tractor models.
If necessary, proceed as follows:
1- Disassemble the two parts of the driveshaft
(male and female).
2- Couple the side with the solid bar (male) to
the machine and the female part in the tractor.
3- Place the two parts (male and female)
parallel to each other (fig.21). The ends which
are too long must be cut.
4- Mark the places where they will be cut. Leave
about 30 millimeters of play on each side.
5- Remove the driveshaft from the machine and
the tractor and cut both sides.