Maintenance - Nogueira HAYNOG-300 Manual De Instrucciones

Maintenance

The HAYNOG-300 requires minimum maintenance to make it work perfectly and achieve a long
lifetime. Therefore, the following are essential measures for these purposes:
- Keep the machine clear from material debris.
- Keep the springs in good operating condition, replacing them whenever damaged.
- Keep the machine properly lubricated.
CAUTION
Verify the tightening of all the fastening elements, after the first few hours of operation, especially the
screws fastening the springs, spring holders, and rotors.
SPRINGS
There are 4 types of different springs used in the HAYNOG-300:
- Narrow left spring - left rotor (blue label);
- Wide left spring - left rotor (blue label);
- Narrow right spring - right rotor (yellow label);
- Wide right spring - right rotor (yellow label).
NARROW
SPRING
20
Disconnect the power take-off and remove the key from the tractor ignition
before performing any maintenance, adjustments, and lubrication
procedures on the machine.
Keep the maintenance are clean. Wet or oily floors are slippery and can be
dangerous.
Always place the machine in a flat location and put shims under the wheels.
Always use the same original specifications when replacing screws and
nuts. Before turning on the machine, check and see if the shields are
installed.
Instructions Manual
WIDE
SPRING