Transport Position - Nogueira HAYNOG-300 Manual De Instrucciones

TRANSPORT POSITION

OPERATING
POSITION
Perform the following procedure to change the
HAYNOG-300 from the operating position to
the transport position:
1- Couple the machine to the tractor.
2- Block the fastener lever on pin A (fig.10).
NOTE:
Move the machine a little to the side (fig.11), to
facilitate the blocking of the lever as shown
above.
14
TRANSPORT
POSITION
FASTENER
LEVER
Instructions Manual
MOVE THE MACHINE
TO THE SIDE
3- Place the two deflectors completely inside
and latch them using the fastening bars.
4- Activate the hydraulic system of the machine
and lift the machine to transport it.
FASTENING
BAR