Lubrication; Driveshaft - Nogueira HAYNOG-300 Manual De Instrucciones

Lubrication

Routine and adequate lubrication is the best guarantee to achieve good operation and long-lasting
durability of your equipment, as well as these factors cut costs and reduces maintenance needs. The
recommended intervals must consider the normal operating conditions. We recommend performing
periodic inspections and use clean and good quality lubricants.
Lubricating with grease:
Lubricate the recommended following places using a grease gun. Use special grease for ball bearings,
lithium soap base, NLGI 2 EP classification.
Before lubricating, clean the grease fittings well as to avoid contaminating the grease.
Replace damaged grease fittings.
The following table shows some greasing recommendations:

1- DRIVESHAFT

The brackets and bars: lubricate after every 10 operating hours.
2- TRANSMISSION (GEARS)
02 grease fittings: lubricate after every 10 operating hours.
3- TRANSMISSION (BEARINGS)
02 grease fittings: lubricate after every 10 operating hours.
Multi H
Lubrax GMA-2
Alvania EP2
Isaflex EP2
Lm2
Maxlub
Litholine MP2
Marfak MP2
HAYNOG-300
Esso
Petrobrás
Shell
Ipiranga
Catrol
Bardahl
Atlantic
Texaco
23