Nogueira HAYNOG-300 Manual De Instrucciones página 17

NOTE:
Changing the position of the springs is done
manually and does not require any tool. Just
the pin ans spring and move them to the
indicated position In figure 18.
3- WHEEL HEIGHT: Generally, leave the wheel
in the lower hole (fig.19).
In more demanding conditions (example:
cutting hay, adjust and place in the other holes
to achieve better results. If necessary, perform
some tests to find the best placement setting.
4- Lower the machine so that the springs in the
front part are near the ground.
5- Operate the HAYNOG-300 at full speed (540
rpm) and observe if the springs touch the
material in front of the machine. If necessary,
disconnect the power take-off and adjust the
third arm point connector to the tractor.
6- After adjusting, turn off the machine and wait
until the rotors are motionless.
7- Place the deflectors as you prefer. Latch the
fastening bars to define and constrain the
spreading width.
It is also possible to change the height of the
deflectors by simply turning the nylon blocker
180°.
HAYNOG-300
BLOCKER
FASTENING
BAR
17