Schlage HSLR L9000 Serie Instrucciones De Instalación página 3

5c Insert posts into holes.
Lock case should
Ì Ì
remain unlocked.
Continue to hold interior plate assembly on door. Failure
to do so may cause personal injury and lock damage.
6
Install exterior plate onto exterior of door.
6a Install spindle and then spring cage.
Arrows on spring
cage must match
lever rotation
direction.
6b Install plate with two screws, but do not fully tighten. Lift up on
interior plate to align posts, if necessary.
Rotate lever away
from door edge
before installing.
Plates will vary based
on lock function.
Actual Size (2)
Use a driver on each
side of the door.
Test function. If operation
is not smooth, lift trim on
door until smooth.
Plates will vary based
on lock function.
WARNING
Plates will vary based
on lock function.
6c CYLINDER FUNCTIONS: install cylinder(s) now. See "Cylinder
functions" on page 4.
6d Install remaining screws, but do not fully tighten.
Plates will vary based
on lock function.
Actual Size (3)
Use a driver on each
side of the door.
7
Fullly tighten all plate and chassis screws.
L
If operation is not smooth, see "Troubleshooting" on page
4.
8
Install armor front.
WARNING
All screws must be flush
with plate. Failure to make
screws flush will result in
ligature hazard.
WARNING
All screws must be flush
with armor front. Failure
to make screws flush will
result in ligature hazard.
Actual Size (2)
3