Schlage HSLR L9000 Serie Instrucciones De Instalación página 4

9
Install strike.
Cylinder functions
a. Install cylinder and spring into blocking ring.
b. Use key to tighten cylinder.
c. Tighten cylinder set screw.
4
Actual Size (2)
Troubleshooting
Lever binding when rotating.
1. Loosen the five (5) perimeter screws on one side of the trim.
(Do not loosen the one nearest the latch.)
2. Push both lever trim assemblies slightly upwards and hold in
place (not too far, but enough to get rid of the bind).
3. Retighten the screws in that position and check operation.
Thumbturn binding when rotating.
1. Loosen the five (5) perimeter screws on one side of the trim.
(Do not loosen the one nearest the latch.)
2. Rotate the plates until they are parallel with the side of the
door.
3. Re-tighten and check operation.
© Allegion 2019
Printed in U.S.A.
P519-054 Rev. 08/19-a