Adjustment Of Chain - Serpento COYOTE 250 Manual De Usuario

Adjustment of Chain

Check the chain for wear, tension and lubrication.
(1) With the motorcycle supported by the main stand, turn the upper and lower portions of the chain by hand to check for its tension to see if
the sag is within the specified range of 10-20mm.
(2) When regulation is needed, loosen the axle nut and locking nut of the rear wheel, then set the chain to the required tension by turning the
adjusting nut.
(3) Apply a little grease to the chain.
Caution:
At the ad of regulation, the marks on the chain adjuster should be in good coordination with the engraved line on the horizontal fork al position
is concerned.
Chain adjuster (with graduations)
Bear axle
Rear wheel axle nut
Braking light switch Adjusting nut
Braking light switch spring
• COYOTE 250
MANUAL DEL USUARIO
25