geberit ECO 203 Manual De Operación página 28

EN
Pressing with Geberit
pressing attachments
WARNING
Risk of injury caused by flying
fragments
▶ Wear protective goggles and a
protective helmet.
WARNING
Risk of injury caused by the use
of incorrect pressing
attachments
▶ Only use pressing
attachments that correspond
to the diameter of the
pressfittings to be processed.
WARNING
Risk of fire from heat build-up
▶ Allow the pressing tool to cool
down for at least 30 minutes
after 30 minutes of continuous
operation.
▶ Do not place or store the hot
pressing tool near easily
flammable materials.
The pressing procedure can be
cancelled at any time. → See
Cancelling the pressing procedure.
Prerequisite
– Pipe ends are deburred and clean.
– The pipe section and pressfitting are
fitted together according to the
installation manual of the piping system.
– The pressing attachment is inserted
correctly.
1
Connect the pressing tool to the
power supply system.
✓ The tool is ready for operation;
the green LED lights up.
28
2
Fit the pressing attachment to the
pressfitting correctly and do not tilt.
→ See user manual for the Geberit
pressing attachments in question.
CAUTION
Danger of crushing
▶ Keep hands away from the
pressing attachment.
3
Press the start button for at least 2
seconds.
✓ The pressing procedure
proceeds automatically after a
force is detected, and the green
LED switches off.
Result
✓ After the pressing operation has been
completed, the roller drive returns to its
starting position. The green LED lights
up and the pressing tool is ready for
operation again.
9007201149220747-1 © 02-2018
968.385.00.0 (00)