Rectifying Malfunctions - geberit ECO 203 Manual De Operación

Cancelling the pressing
procedure
▶
Press and hold release button.

Rectifying malfunctions

Fault
Unable to activate the
pressing tool out of idle
state, no LEDs are lit.
Green LED flashes.
Green LED flashes and
roller drive moves back to
its starting position.
Red LED flashes.
9007201149220747-1 © 02-2018
968.385.00.0 (00)
Result
✓ The roller drive in the pressing tool
Cause
Mains cable is not
connected.
Mains cable or mains
plug is defective.
Retaining pin has
been inserted incor-
rectly or has not been
pushed in until the
stop position is
reached.
Retaining pin has
come loose.
Start button was
released too soon.
Release button was
pressed or pressing
tool was not in
starting position.
Pressing tool is
outside of the
operating
temperature.
returns to its starting position. The
pressing procedure must be repeated for
a complete press connection. The
pressing attachment must not be
removed or rotated at this time.
Action
▶ Connect the mains plug to the power
supply system.
▶ Have the mains cable and mains plug
examined at an authorised repair
shop and replaced if necessary.
▶ Check the retaining pin for damage.
▶ Push the retaining pin in until the stop
position is reached.
▶ Check the retaining pin for damage.
▶ Push the retaining pin in until the stop
position is reached: green LED lights
up.
▶ Check the pressfitting for tightness
and repeat the pressing operation if
necessary.
▶ Press and hold release button: roller
drive moves to its starting position.
▶ Repeat the pressing operation: press
the start button for at least 2 seconds.
▶ Release start button.
▶ Press and hold release button: roller
drive moves to its starting position.
▶ Repeat the pressing operation: press
the start button for at least 2 seconds.
▶ Bring the pressing tool into a warmer
environment or leave it to cool down.
▶ Bring the pressing tool to the required
operating temperature by performing
multiple blank pressing operations
(pressing operations without a fitting).
EN
29