General Operation - geberit ECO 203 Manual De Operación

Operation

General operation

If the pressing tool is not used for 30 minutes, it will switch to idle state. No LED is lit. Tapping
the start button will reactivate the device from idle state. The tool is ready for operation; the
green LED lights up.
Inserting Geberit pressing
attachments
Pressing attachments are pressing jaws,
pressing collars and adapter jaws.
Observe the user manuals of the
Geberit pressing attachments. Check
the pressing attachments according
to the safety chapter.
1
Disconnect the mains plug.
2
Pull out the retaining pin.
3
Insert the pressing attachment into
the pressing tool.
9007201149220747-1 © 02-2018
968.385.00.0 (00)
4
Push the retaining pin in until the
stop position is reached.
Result
✓ The pressing tool is ready for pressing.
EN
27