País
Número de homologación de
radiofrecuencia
Taiwán
CCAO17LP0380T4
CCAO17LP0390T7
經型式認證合格之低功率射頻
電機,非經許可,公司、商號或使
用者均
不得擅自變更頻率、加大功率
或變更原設計之特性及功能。
低功率射
頻電機之使用不得影響飛航安
全及干擾合法通信;經發現有干
擾現象
時,應立即停用,並改善至無干擾
時方得繼續使用。前項合法通
信,指依
電信法規定作業之無線電通
信。低功率射頻電機須忍受合
法通信或工
業、科學及醫療用電波輻射性
電機設備之干擾。
According to "Administrative
Regulations on Low Power Radio
Waves Radiated Devices".
Without permission granted by
the DGT, any company, enter‐
prise, or user is not allowed to
change frequency, enhance trans‐
mitting power or alter original
characteristic as well as perfor‐
mance to a approved low power
radio-frequency devices.
The low power radio-frequency
devices shall not influence air‐
craft security and interfere legal
communications; If found, the
user shall cease operating imme‐
diately until no interference is
achieved.
The said legal communications
means radio communications is
operated in compliance with the
Telecommunications Act.
The low power radio-frequency
devices must be susceptible with
the interference from legal com‐
Llantas y neumáticos 265
País
Número de homologación de
radiofrecuencia
munications or ISM radio wave
radiated devices.
Tailandia
This telecommunication equip‐
ment conforms to NTC technical
requirement.
Ucrania
Model: TSSRE4A & TSSSG4G6
UA.TR.109.0109-17
Emiratos
Huf Electronics Bretten GmbH
Árabes
Model: TSSRE4A
Unidos
Model: TSSSG4G6
TRA
Registered No: ER57807/17
Dealer No: DA36976/14
TRA
Registered No: ER57806/17
Dealer No: DA36976/14
Estados
FCC ID: YGOTSSRE4A
Unidos
This device complies with Part 15
of the FCC Rules. Operation is
subject to the following two con‐
ditions: (1) this device may not
cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
WARNING: Any changes or modifi‐
cation not expressly approved by
the party responsible for com‐
pliance could void the user's aut‐
hority to operate this equipment.
Cambio de ruedas
Indicaciones sobre la elección, el montaje y la
sustitución de los neumáticos
Puede solicitar información sobre las combinacio‐
nes de llantas y neumáticos autorizadas en un
taller especializado.