4�3�2 Mounting The Head - Renfert EASY view 3D Traducción Del Manual De Instrucciones Original

⇒ Place the mouse (11, Fig� 1) next to the desk
⇒ Place the foot switch (Fig� 1) under the table and insert the
cable for the foot switch into the foot switch
EN
4.3.2 Mounting the head
Four washers are needed for mounting the head (see Fig� 7)�
Three small washers (gold/black/gold) have already been thread-
ed onto the fastening screw (31) in the correct sequence� The
large washer is attached to the head with an adhesive strip with a
red end�
⇒ Remove the adhesive tape with the red end�
⇒ Loosen the fastening screw (31) on the support arm�
⇒ Attach the fastening screw with all three small washers through
the adapter of the head�
⇒ Make sure that the three small washers (gold/black/gold) and
the large washer are in the correct order as shown in the figure.
⇒ Insert the adapter with the fastening screw and tighten the fas-
tening screw until the head no longer tilts downward�
4.3.3 Positioning the monitor
⇒ Position the monitor so that it is directly in the field of view. The distance to the observer should be
between 50 and 70 cm�
⇒ Align the monitor (tilt, rotate using stand) so that the viewing direction is perpendicular to the monitor in
all planes (Fig� 8 / 9)�
4.3.4 Adjusting the clamping force
In order to achieve a stable position of the head, the clamping forces of the three joints can be adjusted
individually�
• Support arm
- Fasten the screw at the head (31)�
- Middle clamping screw (32)�
- Clamp screw on base part (33)�
• Swiveling the head right/left
- Clamping screw (34) with the included tool (9, Fig� 1)�
• Height adjustment
- Clamping screw (35) with the included tool (9, Fig� 1)�
pad��
Fig. 8
- 8 -
Fig. 6
31
Fig. 7
Fig. 9
31
32
33
Fig. 10
34
35
Fig. 11